Voron-2
Voron-2 copied to clipboard
VoronDesign
Voron 2 CoreXY 3D Printer design
Added Gear Ration for Stealthburner corner points for 350mm build was uncommented
The Manual states that it is possible to only mount every other screw for the linear rails. With Tap you can see the screw Pattern in the mesh. After mounting...
When I assembled my printer for the first time, my gantry was really out of square. Therefore, the first time I ran quad gantry bed leveling, the nozzle crashed into...
It's a minor issue, but only some of the Chapters in the TOC are clickable links. I've tried with Acrobat DC and Foxit reader, same issue with both. Intro through...
Added Manta M8P Electronics bay mounting bracket Cheers, Takuya
This should be explicit and state "M5 Shim 1mm" as there are two types of M5 Shim in the fysetc fastener pack for V2.4 (1mm, 1.5mm)  the CAD must...
Minor issue but worth highlighting so that it is on the radar. On page 141 the manual ends with an incomplete sentence. Perhaps it should reference the probe cavity? 
The latest CAD file for The Voron 2.4r2 shows a 10X10 drag chain for the Z chain assembly, whereas the BOM calls for a 10X15
I think I destroyed a MCU because of electrostatic discharge from myself. Maybe a small info on page 148 to ground yourself before working with electronics/circuit boards would other save...
The left and right XY-Joints mirror each other in terms of the bearing stack and the GT20 idler. The bolts which holds the GT20 idler screws directly into the plastic,...
