Y-Axis Gantry Page - 89

[KingVeder]

Minor but the screw/T-Nut on the rail should start on the second one in, on both sides to allow for the Idler M3 & M5 T-Nut

[nemgrea]

if the directions on page 88 are followed all of the T-nuts fit properly as shown.

[newphreak]

This is very much a real issue on 300mm builds. I forget the math, but i think the 50mm difference from the 300 and 400mm rails is what makes the 300 (350mm rail) have less space here.

[andreasbeh]

Can confirm this issue exists on a 300mm build, I am about 5mm short each end from being able to fit a M5 ball-spring nut. It fits just fine with a slide-in style nut, though that needs double checking for a 250mm build.

EDIT: The configuration in the pictures does NOT work, the ball-spring nut needs to be flipped around (so hole towards the rail), then it fits with a screw in the last hole of the rail, and a slide-in M5 nut for the end

[asdasdwa-v02679]

hello friends, I hope this edit solves the problem :) let me know if it needs to be changed!

full page :