Voron-0
Voron-0 copied to clipboard
VoronDesign
Voron 0 CoreXY 3D Printer design
The BOM specified GDSTime 24v 30mm blower fans used for the Part cooling fans are susceptible to overheating from being in close proximity to the hotend. Observed behaviour; - When...
First off, nice work! I really enjoyed assembling my machine using a PIF kit, and am eager to start printing with it. During assembly, I kept note of the issues...
When checking for extruder binding on page 117, the picture shows the filament latch closed. But when I tested this with the latch closed (no filament), I got lots of...
On page 16 in the manual you're told to install the rail stoppers, but there's no mention of nuts being shown before page 18. Makes more sense to mention it...
B motor should be connected to XM and A motor to YM but documentation on page 135 & 137 states otherwise.
With permission from Nemgrea, I brought all of the heatset insert holes on the V0.1 to parity with each other. The holes ranged from 4.5-4.7mm inner diameters and 5.3-5.5mm outer...
As mentioned in the title... Should be cheap, and gives more warm-fuzzies for folks!
As far as I can tell, the Revo toolhead is not part of the STEP files available in the VORON_V0.1.zip file and I can't seem to find them in this...
Hi, not sure if it is the right place, but in the Assembly Manual, there's specified two pieces of "G EXTRUSION" on page 15, but further in the manual I've...
Seems that all printed parts for the Panels section have their page number off by one (e.g. 223 instead of 224)
