Venkatesh Bhat

The command curl -sS http://pi.protocentral.com/pi.sh | sudo bash will install all the required overlays, configuration and application files to get the Healthy Pi up , if this does not work...

Could you please attach the screenshot of signals obtained?

Thanks for sharing, where did you place the electrodes? was it on the chest?. Baseline is wandering too much. RA : Red LA: Green LL : Black

I am referring to the ECG signal moving up and down rather than straight. Are you using the latest Ui?

Hello SvenHi, The SerialUSB on Arduino Zero is a is an emulated serial port (USB-CDC). The SerialUSB class is a special Serial instance which use the hardware USB the speed...

Hi ecaits, Sorry for the inconvenience caused, could you please share your design? What other slave you are interfacing with?

@omsrivathsa Sorry for the inconvenience caused, could you please attach the error message you are getting.

Devesh, 1)Are you sure about the i2c lines? 2)Is the RED led on the sensor is glowing? 

The example sketch suppose to plot RED and IR PPG signal. Could you please contact the Manufacture of the board for further queries.

I do not see any issues with the Library/sketchs here. Its pretty much straight forward that I2c lines to be hooked up to the micro-controller. **RED led on the sensor...