ThatBigPrint
ThatBigPrint
will this be a simple OTA update if we used esp mesh for the interim, then upgraded later on?
i have done the research and as far as I'm aware rainmaker is not compatible with espmesh? unless I'm mistaken? if it was I would go with that 100% but...
our requirements are similar to esp mesh but not that critical, mainly easy provisioning and low as possible latency...
if you can share the source for this function I can test for our used case ?
ok, so that was the answer i was after.... so instead of investing in an app based on the old esp mesh one I may as well start with the...
I'm only using it at 150hz and I have tried that On Tue, 2 Jan 2024, 4:07 am shixinke-orion, ***@***.***> wrote: > What frequency did you set for the PWM?...
I'm in airport at the min... Is it true on the esp32 including the d4 I can't call other code until the fade is finished? Or can I pin this...
How will provisioning work? I'm supported esp gave up with esp mesh On Mon, 17 Oct 2022, 2:26 pm Piyush Shah, ***@***.***> wrote: > RainMaker itself does not support any...
Thanks for the prompt reply.... Regards ota can you guys come up with a simple example doing a https get request and deploying, I think that would be most useful...
@jorgie0 just to help out a tad here, basicaly treat the esp mesh just like wifi connect it should be a drop in replacement this is an example from the...