Giorgioggì

Thanks a lot for the information :).

RX is PD0 TX is PD1 The rest of the pins seem to use standard Arduino names, so you should be able to make the correct connections. If the MCU...

The led shouldn't be a problem, but it is surely an odd choice to put it on pin 0 when practically all Arduino boards have it on pin 13. If...

I have just realized that this board uses the ATtiny88, which is a new microcontroller whose existence I wasn't even aware of. At a first glance it seems compatible enough...

I think so, but I cannot test it and don't want to support it without studying the microcontroller and board first (which I don't really have time for, ATM). Whoever...

Just my own 2 cents: you can get a "real" Arduino Nano clone for ~4€ shipped from China, which would make things much easier :).

Note that on this board the USB connection uses PD1 (D+) and PD2 (D-). I don't know the USB protocol well enough but maybe SELECT being connected to PD2 might...

Closing due to inactivity after 1Y, feel free to reopen if necessary,

I don't know anything about the Nano Every, sorry. I hope someone else will contribute a fix.

I'd recommend a $3 Nano clone from Aliexpress.