Stoat

> Got some moderate success on Tasmota with this template: How did you manage to tasmotize it? If I tie down gpio0 then I can't talk to the ESP8266 (standard...

I have some pogo pins on the way in order to 3dprint a chip clip on other devices. I'll make a clip for the SPI and try that, although I...

> Thanks @Leo-PL > On a JQ-200 (no dust sensor), was able to flash Tasmota 9.2.0 with flash chip in-circuit with an 8 pin clamp and pulling pin 13 (esp...

> Not sure if there is a direct way to force local ota update Judging from the plaintext in order to attempt to thwart being put into a sandbox it...

$ binwalk /tmp/jq300.img DECIMAL HEXADECIMAL DESCRIPTION -------------------------------------------------------------------------------- 248212 0x3C994 SHA256 hash constants, little endian 349456 0x55510 CRC32 polynomial table, little endian 355452 0x56C7C PEM RSA private key 355552 0x56CE0 PEM...

$ esptool image_info /tmp/jq300.img esptool.py v2.8 Image version: 1 Entry point: 40100294 3 segments Segment 1: len 0x00574 load 0x40100000 file_offs 0x00000008 [IRAM] Segment 2: len 0x00308 load 0x3ffe8000 file_offs...

send me a private message and I'll fire it over. As the image contains my SSID and Wifi password I'm not comfortable putting it in public

flashrom dropped tasmota-sensors on it happily, but that's not much use in terms of decoding the sensors

Solved the networking problem: (for some reason a space was being appended to the SSID on my android phone browser and I missed this. I'm leaving this here for anone...

NTP sync is working and transmitted to the controller over the 433MHz link Set as HY08 device Temperatures reporting OK (no floor temp) no relay/load status no reporting of schedules...