SN 39XXXXXXX (protocol v4)

[romainlouvet]

Hello,

I try to init this integration for my deye controller SN : 39XXXXXXXX but it doesn't work :/

in this doc ->

Check the version of the solarman logger. If the serial number starts with 17xxxxxxx, 21xxxxxxx or 40xxxxxxx (protocol V5), the component should work. If not, you may need to try the component for V4 of the protocol mentioned above.

Where can I find this v4 component?

thanks

[HA-Moll]

I have the same problem with an inverter "deye sunm100g3 eu q0 Firmware 2.32" Here some warnings from the log: Querying registers [1 - 125] failed, aborting.------Querying [1 - 125] failed, [1] retry attempts left Querying [1 - 125] failed, [0] retry attempts left---------2024-02-08 11:43:18.143 WARNING (SyncWorker_10) [custom_components.solarman.solarman] Querying [1 - 125] failed with exception [V5FrameError: V5 frame contains invalid start or end values]

What could the solution look like? Or do I have to wait for an update because the inverter is still too new? Thanks for help

[real-intruder]

Same Problem Could it a Problem with the external Relais? The App Solarman shows the correct Values... with the correct ID of the Logger

[meerlaender]

The same Problem SN 39XXXXX

what is the V4 must i use an older Solarmann Version or wait for a newer?

THX for answer

[Jaapk]

I seem to run into the same issue - any solution?

[wandi34]

Same problem here

[nandogandra]

same problem here also- Logger 39XXXXXXXX

[robertugo2]

I think author of this repo is suggesting to use 1.4.x version of this custom component. I noticed, that 1.4.x is working fine white 1.5.x is not working at all. I have Sofar hybrid inverter.

[bassam0944]

How can I change protocol v5 to v4