Statisticss

During the evaluation I found the detected anomalies tend to lag for a while after the true anomalies. This phenomenon was also mentioned in your paper: "A potential downside of...

What does the ah register offset 0x8344 stand for?

2

Hi Yaxiong, I found that in hw.c, you set the 28th bit to 1 in the ah register with offset 0x8344. I don't really get the reason of doing that...

Hi Yaxiong, Thanks for your great tool! These days I found a problem: when I send a packet, there is only one CSI recorded in the receiver. However, as far...

Hi all, In order to investigate the property of CSI, I have performed the following test: I use 1 Tx, 2 Rx, all in monitor mode with a single antenna...

Hi everyone, I am using the CSI tool in the 2.4GHz band under the monitor mode. However, when I send 100 packets consecutively, the receiver sometimes can only measure 70-80...

CSI amplitude not stable

14

Hi everyone, When I was plotting the amplitude of CSI, I found that it seems like there are two levels, as the figure shows below: I was wondering why it...

Hi all, Currently I'm trying to get the transmit TSF timestamp, in addition to the receive timestamp provided by this tool. However, I cannot find the place where the NIC...

Hi, I have a question regarding the results in Table 8 and Table 14 (05 Dec., 2023 version). In Table 8, for 7B context length 8192, the ppl for full...

Thanks for this great work! I have several questions regarding the datasets and the corresponding models: Q1: I think you have used RedPajama for FT and LongAlpaca-12k for SFT. You...