OrcaSlicer
OrcaSlicer copied to clipboard
Enable "Change Filament" Option when printing in Spiral Vase mode
When in preview mode, after slicing a model in vase mode, in PrusaSlicer it's possible to press on the + icon in the right layers-slider and add a filament change command.
In Bambu Studio and Orca Slicer this feature is disabled. Is there an option to make it enabled?
Its working pretty good on prusa Mk3s+.
Adding to this as I noticed this same thing, even when not in Vase mode.
I had to disconnect my ams from x1 C and via side loaded filament, I was not able to do a simple layer height filament change. I had a small part I printed multiple times using these options all turned to a single color item: -Filament 1 set to first section then layer 15 change filament to Filament 2 (no pause, just single color printed) -Filament 1 set to first section then layer 15 change filament to Filament 1 (no pause, just single color printed) -Filament 1 set to pause, but then I was unable to change filament on the printer or via handy app. (I didn't test in the slicer)
I also tried in bambu labs slicer and was NOT able to make this happen as well. I have the default filament start and end gcode.
Following this, would love to do multicolour vases!
Im also waiting for this...
GitHub bot: this issue is stale because it has been open for 90 days with no activity.
I'd also like to see this - primarily so that I can add any sort of gcode as a marker to merge vase and non-vase print gcode. Also not entirely sure I understand why it's intentionally disabled to begin with?
Also keen for this. Just doing a custom M600 currently, however that doesn't handle different material types/temps/flow rates.
I'd also like to see this - primarily so that I can add any sort of gcode as a marker to merge vase and non-vase print gcode. Also not entirely sure I understand why it's intentionally disabled to begin with?
Presumably because spiral mode is a single continuous line from bottom to top. Any pause would result in artefacts. Maybe it should just be a warning though, so one could experiment with it.
I'd also like to see this - primarily so that I can add any sort of gcode as a marker to merge vase and non-vase print gcode. Also not entirely sure I understand why it's intentionally disabled to begin with?
Presumably because spiral mode is a single continuous line from bottom to top. Any pause would result in artefacts. Maybe it should just be a warning though, so one could experiment with it.
Yes, I think this is the way...
Orca bot: this issue is stale because it has been open for 90 days with no activity.
commenting to avoid staleness