First Layer Travel Acceleration

[Z18Aplha]

Is there an existing issue for this feature request?

• [X] I have searched the existing issues

Is your feature request related to a problem?

Normally, a low acceleration value for the first layer is necessary for good bed adhesion. But unfortunately the acceleration value also applies for the travel movements, which is not optimal. This supports stringing and oozing.

Which printers will be beneficial to this feature?

All

Describe the solution you'd like

It would be nice to add a "first layer travel acceleration" parameter like the "first layer travel speed" which already exists. I opened this issue again, because #2797 was closed some weeks ago but i think there is really a need of this setting.

Describe alternatives you've considered

No response

Additional context

No response

[vgdh]

It will be very useful feature! This is so annoying I am almost at the point of writing my own post script for changing acceleration at first layer.

[vgdh]

I've wrote a postscript for fixing this issue. It fixes this annoying behavior for the first layer. https://github.com/vgdh/OrcaSlicer-first-layer-travel-acceleration-fix

[vgdh]

I've updated the acceleration fix script, now it works very fast.

[Z18Aplha]

Thank you very much!

[github-actions[bot]]

Orca bot: this issue is stale because it has been open for 90 days with no activity.

[github-actions[bot]]

Orca bot: This issue was closed because it has been inactive for 7 days since being marked as stale.