Luban
Luban copied to clipboard
Snapmaker
Bug: 4.30.1 ALPHA top/shell preview in 3d printing
New Alpha, has preview issue, direction of shell/top line when thin wall (one outer surrounding one middle/shell/top line) see private beta post https://forum.snapmaker.com/t/g-code-solid-preview-alpha/26215/4?u=tyeth
Also struggling to get overlap detection working with these models once I add and arrange multiple duplicates, and I also then tried auto-arrange which did a beautiful arrangement, but off the bed and missed one of them (flipped 180 it tucked into the corner and all fit in the snapmaker original square) plant_pot_risers.zip .
New Alpha, has preview issue, direction of shell/top line when thin wall (one outer surrounding one middle/shell/top line) see private beta post https://forum.snapmaker.com/t/g-code-solid-preview-alpha/26215/4?u=tyeth
It's a G-Code issue, we will check it.
Also struggling to get overlap detection working with these models once I add and arrange multiple duplicates, and I also then tried auto-arrange which did a beautiful arrangement, but off the bed and missed one of them (flipped 180 it tucked into the corner and all fit in the snapmaker original square) plant_pot_risers.zip .
As for this, when there is no place arrange extra model, it will be off the bed.
Thanks Jane, I was aware of the off-bed auto arrange issue, but the overlap detection not working is an issue. Try the auto arrange with a couple of each of those STLs, it should arrange them easily.
On Thu, 9 Jun 2022, 12:24 jane, @.***> wrote:
Also struggling to get overlap detection working with these models once I add and arrange multiple duplicates, and I also then tried auto-arrange which did a beautiful arrangement, but off the bed and missed one of them (flipped 180 it tucked into the corner and all fit in the snapmaker original square) plant_pot_risers.zip https://github.com/Snapmaker/Luban/files/8864232/plant_pot_risers.zip .
As for this, when there is no place arrange extra model, it will be off the bed.
— Reply to this email directly, view it on GitHub https://github.com/Snapmaker/Luban/issues/1618#issuecomment-1151000997, or unsubscribe https://github.com/notifications/unsubscribe-auth/ABTBZ45VTRLMIRVNRN2THC3VOHH7ZANCNFSM5YHGBQNQ . You are receiving this because you authored the thread.Message ID: @.***>