SmartEVSE-3
SmartEVSE-3 copied to clipboard
SmartEVSE
Smart Electric Vehicle Charging Station (EVSE)
The home energy meter reports the incoming supply voltage in excess 250V consistently overnight, peaking at 256V in the middle of the day. What behavior of SmartEVSE shall expect charging...
Currently i'm using a E20 p1 from zuidewijk. Currently i'm planning getting ethernet wired to the garage as i don't have wifi there. I'm wondering if there is a way...
The SmartEVSE v3 does not continue charging once the PE wire is disconnected from the SmartEVSE terminal (CP-PP open loop) but still can operate and continues charging with no PE...
Hi, The minimum charge current for the car per phase cant be set lower then 6A. My car (MG4) accepts 6A total (3 phase), and 2A per phase. To charge...
I have connected the SWITCH terminal of my SmartEVSE3 to a switch actuator of my KNX installation, so I can trigger the EVSE on/off based on the lowest hourly electricity...
As one of the developers of the serkri firmware, I hope you see us as adding to your business, and not as competitors (because we are not :-) ). For...
Hi. I must be missing something trivial, but I can't find any code line to unlock the Type connector when power fails. Now to think about it I don't see...
The SmartEvse with FW. 3.0.1 and in Solar mode with -0A Startup. Mains at 10A and Max at 18A. Single phase. On plugging in the car I register a current...
Hello, I am interested about EVSE unit, but I can't find any information about the operational temperature range (eg. -20°C to +60°C ??). Could you provide this info, please? Thank...
