Alessandro Negri

Have you done a thermal calibration after the hardware changes?

why pulley homing?

Ok but during homing the pulling don't move at all.. Il lun 10 giu 2019, 13:57 chriswal ha scritto: > when filament is removed no pulley homing for error handling...

Obviously the pulley. Your fix is similar to mine but more in detail. Pulley in homing is not necessary, so a lot of program is erasable... Similar to move_proportional... And...

I'm at work and to program is not my job. This night I try your change and I will say if it works fine. Bye Il lun 10 giu 2019,...

ok i tried your version: this is the video https://photos.app.goo.gl/ACRHHLtMw1cEbMv98 this is my homing version: https://photos.app.goo.gl/jmi8YH8ULKjGrP376

ak47 still shooting (shorter..).. in my version after 2 days on stallguard without good solutions, i decided to compare stallguard value of every single step. so when it rises over...

wow, it work fine. in my project studying the datasheet of tmc2130 i see that when the motor is spinning too low the value of sg is not stable. with...

 at near to zero spin motor i use this part of datasheet

my mmu2 is assembled with hyper mega shitty cinese motors, board and cables. so if your it's original we have the best and the last for testing. between there is...