Riccardo Rizzo
Riccardo Rizzo
@adam-pulley you can also check on the at command manual of the sara u201, **be careful we not support and not encourage the use of this commands, sorry**, say this...
Hi all, i start to work on this issue, i looking into reproducing the problem.
ok @FrancMunoz thank you, i'll try it, have you used a particular sketch to reproduce the issue?
ok @FrancMunoz you talk about the timeout in the waitFoResponse() in modem.h correct?
Hi @Basi0815 i'm testing your sketch and seems work it run until yesterday, could you enable the debugger by setting the GSM gsmAccess(true) and share the results?
@FrancMunoz i have test your library and also for me it hangs generally after one day, i had experienced the freeze in writing operation and only one time in `+CREG`
Yes the board is really sensitive to the power plant, and also to the quality of the signal. You can check some data about the connection quality by using the...
The second and the third parameters are releted to signal and service, from the manual: ``` "signal": signal quality. See mapping in the note below: - 0 (< -105 dBm...
ok @FrancMunoz i'll try your version of the core immediately, while i had try to reestablish again the connection with the module and try to manage the delay from sketch....
Hi @ardiri why you need the value of _state? is not sufficient the value returned by ready()