Marlin

Marlin copied to clipboard

hi i try to use M43 P63 W (pin 63 to get signal from sensor) if sensor on pin 63 return 1, if not return 0 (pin 63 is unused),...

lunknowl

With one extra sample at the center after you determine the plane, you could calculate the horizontal rod radius.

laurentopia

I want to modify the constant that calibrate the high between the extruder and hootbed ( see the picture below).  What's the defined constant to adjust it? The issue...

MrFiregore

After homing, the hotend start heating! If any movement to accomplished, continues to heat up to 250C. When it is stopped for a few minutes, the temperature starts to slow...

Betuka

In the programme, you can see this : // Set E direction (Depends on E direction + advance) for(unsigned char i=0; i

jaune74

Greetings I hope you are well, my name is felix and I am super new working with 3D printers. And I currently have a mini rostock, with a proximity sensor...

felixpujols007

"Infinite" calibration interations

17

I used G30 A command to start auto calibration, but it seems that it's never going to stop... I'm now running more than 30 iterations, but still not stopping. What...

cacomistle

How to change X and Y to Z-probe

1

hi, thank you for this marlin, but how to change x and y to z-probe because I can only change the value Z, please ?? I said that I already...

Dimroy

Confusion about tower names

3

I'm a little confused about tower names. Could you clarify? My X motor is plugged into my front-left tower, my Y motor is the front-right tower, and the Z motor...

digiexchris

AutoCal with Hall effect not working

1

Hi, Works Ok with Mechanical switch , but when i use a hall effect, it seems to keep sampling as the probe is retracting for an over sample. This results...

c3D-Dan