ribbit-network-frog-hardware
ribbit-network-frog-hardware copied to clipboard
Ribbit-Network
The sensor for the world's largest crowdsourced network of open-source, low-cost, GHG Gas Detection Sensors.
I think a few folks (including myself) have had issues when connecting to the frog sensor over wifi, and connecting the sensor to their local wifi network. I wanted to...
After lots of excellent learnings from the Frog Sensor Alpha Test Users, it is obvious that we need some additional error/status information to be displayed for each sensor to debug...
There is a potential concern with low outside temperatures causing problems with sensor accuracy or even the ability to operate. Below is a table of recommended operating temperatures for each...
The CO2 container supports both reading from an I2C sensor that uses I2c or a USB connection. If an I2C GPS is used, the GPSD container however, will spam errors...
One of the common complaints about the Frog Sensor is that it is difficult to quickly determine the status of the sensor (is there an error? Is it connected to...
See if we can reduce the sizes of the images to speed up updates, which allows a new device to come online faster and makes developing for our devices less...
In order to enable the USB Power on the Wavehsare Carrier board we use for the Raspberry PI CM4, a dt_overlay variable must be set. [Wiki link to the documentation.](https://www.waveshare.com/wiki/CM4-IO-BASE-A)...
As part of the effort to create an EPS32 based Golioth Frog Sensor https://github.com/Ribbit-Network/ribbit-network-frog-sensor/issues/126 , we need to find and integrate drivers for the Frog Sensors into the ESP-IDF framework...
Hey @eaudiffred ! As we discussed in our team call earlier, I have fairly high confidence in the new processor that we would use for the microcontroller based version of...
Metadata
Owner
Metadata
The sensor for the world's largest crowdsourced network of open-source, low-cost, GHG Gas Detection Sensors.