RainbowMiner

Sidenote and hint: I would rather reduce the number of pools in your selection. Some are redundant, with your momentary configuration. This would be my recm. for your PoolName in...

So all the hashrates of the created rigs on MRR are the correct sum of all GPUs, but the rig does start MRR on only on some GPUs, right?

> you dont recomend solo mining? I do, but you should know which coins to use for solomining. My way is the following: I let ZergPoolCoins run and then I...

> ani way i reset all and maybi now also whit the update go well i tell you later but think is not updating balues when change the gpus and...

There shouldn't be too much extra benchmarking, since all the single GPU benchmarks have already finished. RainbowMiner sums up automatically.

But do not forget to edit the combos.config.txt beforehand. With the proposed configuration, you will have a "kind of" device mode, but with that one combo for all GPUs together....

If you like to experiment, there is in fact another possibility, that uses `"MiningMode": "device",` With the following solution, RainbowMiner would create all rigs for each single GPU on MRR...

But: you should then remove all old MRR rigs on MiningRigRentals, that imply "Elfuturo" (use Setup.bat and go to MRR setup) or if you are lazy, simple change your Worker...

Oh, final note: make use of ExcludeWorkerName in pools.config.txt/MiningRigRentals section ``` "MiningRigRentals": { ... "ExcludeWorkerName": "Elfuturo,Elfuturo1,Elfuturo1060", ... }, ```

Thank you! Since VisualStudio takes some time to launch if it's not currently running, I am also often using Ultraedit to edit the config files. It has a beautiful and...