fixed cursor hardcoded to refresh at 60fps

[FridgeRr]

Tested using latest cnc-ddraw with the renderer being direct3d9, minfps=120,maxfps=240 on a 240hz monitor, as well as cnc-ddraw onto dxvk. singlecpu=false to be set in cnc-ddraw.ini is recommended if any initial problems are observed, as well as updating your cnc-ddraw. Attached are the ddraw.ini settings I used. Note that refresh_rate=240 here, changing this to whatever your monitor uses may allow more compatibility. Note also that if you make a change to(mo install as example) mo/resources/cnc-ddraw.ini, make sure the change also applies to mo/ddraw.ini. For some reason I had to delete my ddraw.ini every time I made a change to my cnc-ddraw.ini. DDRAWSETTINGS.txt

also for some reason this commit has some git submodule jank

[github-actions[bot]]

Nightly build for this pull request:

• compiled-dll-9d322f1a1e96153e52db904c89bdb106e653a1d9.zip These artifacts will expire in 90 days and will not be available for download after that time.

This comment is automatic and is meant to allow guests to get latest nightly builds for this pull request without registering. It is updated on every successful build.

[CrimRecya]

If there is no need to design a switch, I think only DEFINE_PATCH(0x7B853C, 0x01); is needed?

[Metadorius]

So what's the status? was anyone able to test this?

[Starkku]

I tested it but couldn't discern any difference but I have a very slow screen anyway.