ZX8 Expansion Module

[burghs]

Alarm system

SP6000 Panel, IP150+ Internet Module & ZX8 Expansion Module

Environment

Running the latest HA update 2023.05 on a Intel NUC

Question

My SP6000 has 8 Zones and then I have the ZX8 Expansion Module( which provides a further 8 Zones and 1 PGM. PAI detects the SP6000 8 zones and 4 pgm's however not the ZX8 modules 8 zones and 1 pgm.

Is it possible to get the integration to see these as well perhaps ?

[MrG01]

Hi @burghs ,

When you log into babyware, can you see all the zones? Can you also check what your "limits" configuration is set to at present? Have you taken a look at what topics show up, when you browse the MQTT broker, under the "paradox" section?

I have the same setup, and for me at least, I am able to see all 16 zones. I have attached what my limits configuration looks like, if it can be of any assistance.

zone: auto user: 1-3 door: "" pgm: 1-5 partition: auto module: "" repeater: "" keypad: "" key-switch: ""

Regards G