PaddleStroke

I've been asked to snap to line middles before. It's not creating a auto-constraint but it should actually. It should create a symmetric constraint. But no one has done it...

3 Double click only select edges forming a wire. Constraints does not matter, only that the start/endpoint of a edge is at the same position as another point. 4. yes...

@xtemp09 I think this is causing more issues : - In my assembly card 9 PR, clicking OK/cancel in the task panels crash. - Clicking OK is crashing int the...

I am currently building it and somehow these commits are triggering almost full rebuilds so I don't know yet. I have seen your fix after posting actually. I'll feedback soon.

I confirm that your fix fixed them

@wwmayer @chennes Any comment on this drag & drop behavior? If no one is against it I propose to : - Remove special modes from occuring when basic drag&drop to...

> The problem is that there is too many special modes, which makes it impractical to assign an one to one relation to some modifier key combination. The current behavior...

Thanks @realthunder I made a PR to comment out this block as you said and it does fix the most important bug (torus replacing origin elements). Other behaviors, such as...

Showing a surface whenever a wire is closed would help. Picture by jetjaguar on discord : 

Also the idea of changing point colors based on coincidence status. See discussion : https://forum.freecad.org/viewtopic.php?style=8&t=76139&start=30