P33M
P33M
@pelwell does the DAC also work fine under those conditions if plugged into one of the USB2.0 ports? @zxmak please post a full `sudo lsusb -v` for your DAC.
* Which operating system? * How have you installed openOCD, and where from?
You're reading the wrong driver. `bcm2835-sdhost` is used to drive the SD slot on 3B+. Even so, in both drivers, overclocking is possible, and it's a requirement that the card...
The parameters are a bit funky - to disable the FIQ codepaths, you need both `dwc_otg.fiq_enable=0 dwc_otg.fiq_fsm_enable=0`. The FIQ has no real beneficial effect on a 64-bit kernel as it...
Pericom PCIe switches have a somewhat onerous requirement to supply the refclk far in advance of releasing reset - does this Microchip PM04100 (or by inference the downstream device(s)) have...
At this stage it's more likely to just permute the set of errors you get. There's no guaranteed maximum interrupt latency with this patch series.
Rebased on 6.12 and tested on a 3B+ (arm_64bit=1/0) and was functional in each case.
Performance Degradation and I/O Errors with Btrfs RAID, Multiple USB-to-SATA Disks on Raspberry Pi 5
Beware cheap SATA adapters that claim to use 12V, but they cop out by drawing 5V from Vbus instead of regulating it internally, assuming that most of the current draw...
Can you elaborate? Which define breaks stuff if not defined?
> If I remember correctly, at least one of the Z-Wave dongles is/was seriously non-USB standards-compliant. @P33M? It was an Aeotec dongle and the symptom there was "failure to enumerate"...