No output after running oskar_fit_element_data

[miguelrgranda]

Hi,

I want to use my numerically-defined antenna element pattern data in the simulation. Following the instructions on Telescope model>Numerical Element Patterns I wanted to run the Stokes I mode only, so I created an ascii table with three columns (Theta [deg], Phi [deg], Amplitude) with comma delimiters. I managed to run oskar_fit_element_data without errors with this output:

| + Loading scalar element pattern: OSKAR_BEAM/beam_MeerKAT_I_1070_MHz.txt | + | + Fitting surface Scalar [real]...

But when I look to the directory in which the output should be stored, I find no fitted file. Do you know what is happening? By the way if you can provide an example of the input beam file I would appreciate it.

Thanks in advance!