homebridge-mcuiot icon indicating copy to clipboard operation
homebridge-mcuiot copied to clipboard

Published 20 hours ago • verified publisher icon NorthernMan54

MCU stops working after a while

Open yghelmut opened this issue 5 years ago • 1 comments

Hello there,

I successfully build this project and added it to Homberidge. It works fine for about 12-16 hours, then the led stops blinking and the nodecmu seems to be turned off. Unplugging it and plugging is in again solves the problem for the next 12-16 hours and so on. Any ideas why that happens ?

yghelmut avatar Jan 02 '20 13:01 yghelmut

If you run it connected to esplorer then the serial console may give some clues

On Jan 2, 2020, at 8:17 AM, yghelmut [email protected] wrote:

 Hello there,

I successfully build this project and added it to Homberidge. It works fine for about 12-16 hours, then the led stops blinking and the nodecmu seems to be turned off. Unplugging it and plugging is in again solves the problem for the next 12-16 hours and so on. Any ideas why that happens ?

— You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub, or unsubscribe.

NorthernMan54 avatar Jan 02 '20 16:01 NorthernMan54