OctoPrint-FlashForge
OctoPrint-FlashForge copied to clipboard
Mrnt
OctoPrint plugin to support closed source printers from FlashForge, PowerSpec, Dremel
First: thank you so much!! During/ after streaming the file to SD the connection times-out. Set communication time-out to 60 seconds. Haven't touched anything during streaming. This happens when I...
I'm new to octoprint, but have experience in programming IoT devices. I have a 3D45 and looked at trying out the octoprint plugin for it. Have it installed on Raspberry...
Thanks to the group on FB, we have a preliminary gcode document [Dremel GCode Protocol.pdf](https://github.com/Mrnt/OctoPrint-FlashForge/files/5228278/Dremel.GCode.Protocol.pdf)
This might be 'the way it is', but when the flashforge finishes a print from Upload to SD method, I have to power cycle the printer to -re-connect. Is this...
Hi, I used Upload to SD card, then printed from that - I get these kinds of messages in the log 2020-09-25 14:43:37,492 - octoprint.plugins.flashforge - DEBUG - rewrite_gcode(): dropping...
Happy to provide debug logs, just not sure which ones you want. And happy to be a guinea pig to test things out. I can load and hit print on...
Flashforge Finder v2.0 Firmware 2.2.7.299 F2.12.2 20181203 controlling print head from #control tab with arrow buttons doesnt work as desired and dosent take home buttons at all. ie. setting stepsize...
Please support when you can. holding off buying the hardware for octo print till i have something that'll connect the creator 3
Hi, Would it be possible to add the Flashforge Guider II. Also ... would this plugin expose data such as the printer status - printing / paused / complete /...
This is a fresh install of octopi on a pi4. The only plugin I have installed is this one. I know the cable is good as I can plug in...
