MrJake222
CubicChunks Compatibility
Above Y=2047 or below y=-2048 DHD will not react to inputs. It won't light up when symbols are pressed or give a no gate in range message when center button is pressed without a gate. Tried dialing in to a gate that was above y=2047 from a gate at a working height and was told there wasn't enough power so I set the power requirements in the config to 0. The gate successfully dialed but I didn't get teleported when I walked through.
Was using Aunis-1.12.2-1.5.0-beta-hotfix3.1
Not issues but worth mentioning, pages will still give an address when used on stargates outside the working range and DHDs will still accept power crystals.
The gate didn't even render below -2048... I really doubt it's my fault. Even the Curse page for this mod says it can break mods.
