voron-bedpan

voron-bedpan copied to clipboard

How is this suppose to fit a voron 2.4 ??? its like 18 mm to low

Hun73rdk

Since 6x3mm magnets are more common than the 10x5x3mm magnets it would be nice to provide an alternate cover/wagomount to use those. This would mean the BoM would be 8x...

jsaintrocc

Teuflor

Hey there, love this print. What type of nozzle brush are you using here.

loopj

Where does the Z endstop go?

1

I don't see the z endstop anywhere in your little video there so i assume you don't use one?

LAP87

Suggestion for securing the nozzle brush

1

An idea for adding a brush securing method, just 2 m2 holes in the front for self-tapping screws into the side of the brush plastic. 

LoganFraser

No matter how much I look at it I can't figure out how to print the bucket, especially in "any orientation with no supports"? No matter how you place it...

Steiner-SE