Michael-Jacobsen

> Did you fix it? Cause I want to install same Hardware. No, I am still talking with BTT about it. Maybe I just have a defective board or 31865...

> @Michael-Jacobsen Would you be so kind and share your config? I have the same error but no temperature is shown What part would you like? The whole thing or...

Made the mistake of buying a new EZ31865 and trying it on all other motor ports. Of course its exactly the same. This board is going in the bin. I'll...

Hi Gianguardo Yes that is the same error I get. I can get the sensor to work until the part cooling fan is turned on. It seems to be an...

> I finally got mine working. The onboard SD on the SPI BUS was causing issues. Add the below lines to printer.cfg to set the onboard SD CS pin to...

I still can't get EZ31865's to work. I just get constant thermocouple faults or reading of -250C very briefly. I have double checked that I have the Dip switches correct...

[klippy (2).log](https://github.com/bigtreetech/Octopus-Max-EZ/files/12047048/klippy.2.log) The klippy log is kindof large because of all the restarting. The configs used are in the log. I have tried Motor8, Motor9 and Motor10 ports At the...

> I didn't notice any issues in the config. I just tested my setup in ports 8, 9 & 10 and it does seem like there is some hardware issues...

> @Michael-Jacobsen did you manage to get this working? I'm suffering the same issue with my 2-wire PT1000 and setting > > ``` > [static_digital_output my_output_pins] > pins:!PB12 > ```...

It does seem like there is some issues of some type with power. I get intermittent warnings of low power to the Pi4. I bought a bunch of different short...