Malderin

I was able to start the filamet runout sensor. Look here: https://github.com/makerbase-mks/Mks-Robin-Nano-Marlin2.0-Firmware/issues/66#issuecomment-729179983

> @Malderin Thanks. On my system, I don't need anything for the filament sensor detection to work (in fact, I'm almost sure it ignores the enable ifdef anyway). My configuration...

I confirm all of the above. I hope the file transfer will be completed. Want to add. If there is already gcode on the memory card, it cannot be run...

if you have a filament runout sensor, disable it. It doesn't work in this firmware, I had such a problem with this.

> #define FIL_RUNOUT_ENABLED_DEFAULT true I have to enter here "false" should be so //#define FILAMENT_RUNOUT_SENSOR

> I have //#define FILAMENT_RUNOUT_SENSOR and don't work :( >  Do you have a filament runout sensor? Disconnect the cable from it

> I recently bought the Sainsmart Coreception 300 which also uses the MKS Robin Nano V1.2 board. It works fine with the dated standard firmware (which seems to be from...

Заглавные русские буквы почему то не поддеживаются, по этому, когда я переводил все это для добавления в прошивку, использовал только строчные буквы.