LINX

LINX copied to clipboard

Add mac support if possible. Alternately could add a button that launches correct firmware example (might be hard due to IDE versions / locations)

samkristoff

See: https://www.labviewhacker.com/forums/posting.php?mode=reply&f=12&t=137

samkristoff

https://learn.adafruit.com/adafruit-motor-shield-v2-for-arduino/overview

samkristoff

Arduino and ChiKit use little endian, LabVIEW uses big endian. This is a problem when transferring multi byte values from LabVIEW and casting them to their corresponding values in the...

samkristoff

Hi @sharpk, @spathi, /dev/serial0 (ttyAMA10) is wired to the UART connector instead of the 40 way connector on the Raspberry Pi 5. It can be accessed from the LINX toolkit....

albsbc

Trying to use Linx with STM32F4

4

Hello I am trying to develop custom firmware with linx to talk with STM32F446ZE board(BTT octopus V1.1). the board is working using custom firmware built using platformIO, now i am...

L1ikhith

Installed LabVIEW on an armbian embedded board, but cannot call the serial port

7

Dear developers and maintainers, I installed LabVIEW on **WuKong Pi**, a single board computer running Armbian, as shown in the picture: But I encountered a problem. **It can only run...

ericddm