MSL-DA

I have triple checked by restarting my pi 4, my phone and Apple TV (iOS 18.2, tvOS 18.2) and “not responding” is gone.

I'm pretty sure that ipv6 is not disabled for you who experience "No response" Check with cat /proc/sys/net/ipv6/conf/all/disable_ipv6 if the result is "1" then ipv6 is disabled.

The 'Not Responding' message is gone and does not come back on restart. HomePod mini and Apple TV 4K (OS 18.2), iPhone iOS 18.2 ``` >> Display Config Start. From...

> @MSL-DA, can you say which is the "preferred hub" in your system, please? Yes ... Apple TV 4K (third generation) I also have a 4K (second generation) which gives...

I've had success removing and adding sps before, but when I restart the Apple TV/and or sps, 'Not Responding' pops up again. But not after I disable ipv6. I have...

> Hey! i've the same issue, i tried disabling IPv6 and removing the speaker on HomeKit, now i can't add the speaker, it gives "unable to add accessory, check if...

After updating tvOS to version 18.3 beta, I again had to remove and add my shairport-sync device. Since then I have not experienced any problems.

Does anyone know if this has been fixed with iOS18?

> I updated my coordinator to 8.0.2 yesterday and everything works the same as before. Means, AFAICS nothing is broken with 8.0.2 Same experience here ``` Zigbee2MQTT docker> 1.40.2-dev Home...

> which file i must use for the dongle E in coordinator mode inside Jeedom ? https://github.com/darkxst/silabs-firmware-builder/releases/download/20241102/zbdonglee_zigbee_ncp_8.0.2.0_sw_flow_115200.gbl (Zigbee)