MarlinKimbra
MarlinKimbra copied to clipboard
MKFirmware
📟 MK 3D Printer Firmware for Arduino
buonasera a tutti, vorrei sapere se qualcuno ha provato a installare un laser su una stampante delta
hi. I work with a cartesian 3d printer with a MarlinKimbra firmware. In printing plug shapes as shown as in the figure below, parallel segments are approximated and distanced every...
I am building a large printer for which I use MarlinKimbra4. I use a Ultratronics V1.0 Pro board. . I have no problems uploading the file to the board (with...
i wanna know the state of a specific pin on my ramps 1.4 . i'm using mega2560 . but the "M43" doesnt work . when i execute this gcode in...
Hi, Using 4.3.9 Configured with the online configurator. Have 2 nozzles set up by adding the following to configuration_overall.h #define SWITCHING_NOZZLE #if ENABLED(SWITCHING_NOZZLE) #define SWITCHING_NOZZLE_SERVO_NR 0 //#define SWITCHING_NOZZLE_E1_SERVO_NR 1 //...
Hi The MK4Duo fork supports extra endstops for the extra motors Where do I connect the wires to? It in is Feature and in Configuration Cartesian tabs Please be very...
Nozzle clean feature currently moves the Z position which is not needed in a system where the bed moves up and down. Is it possible to assign in the Configurations_Fearture.h...
Just power off both heater and bed :((( Two different (mirrored) pcs at the same heigh. Hardware: DUE+RAMPS-FD+LV8729 (XY) 8825 (Z+E) Repetier, Marlin 2.0 works well `/** * MK4duo Firmware...
hi everyone,i have a problem with z-wobble when i load the marlin firmware 3.6, I use this firmware in two diferent 3d printers. This is my current configuration_oveall and I...
So I'm trying to configure Kimbra for my dual extrusion printer. In configurator I have selected: -Ramps 1.3/1.4 (Power Outputs: Hotend 0, Hotend 1, Bed) -Heater 0 Pin: Heater 0...
