Wrong movement at delta autocal.

[Arhigos]

I'm trying to setup mk4duo with my printer. I was able to do everything, only one issue that i have is when i'm doing autocalibration after homing it deploy pin, then moves to the middle and and start slowly moving UP instead of DOWN. and waiting for the pin to probe bed.

Other than that i can control and move everything in pronterface up and down, i can print models (if i remove g29 from begining in my g-code). I can deploy and stow sensor and it report triggered/not triggered correctly.

Configuration_Overall.txt Configuration_Pins.txt

Firmware version

4.3.9

My setup

Ramps 1.5 Atmega2560 Bltouch v3.1 (authentic from antclabs)

Looks like there was pretty similar issue that is already resolved https://github.com/MKFirmware/MK4duo/issues/420