pegstr

pegstr copied to clipboard

Closed bottom is not working

4

Hello, I was trying to generate a simple bin or box, I can't get the bottom to generate fully  unless I also set the strength to 1.0, which breaks...

aditanase

This is a draft pull reqeust for adding support for Honeycomb Storage Wall https://www.printables.com/model/152592-honeycomb-storage-wall/files closes #14

blitzaxt

I have started using the Honeycomb Storage Wall which is a really cool project that replaces a pegboard with a printed hexagon board. I have often used the Pegstr project...

blitzaxt

I found a small problem with "holder_cutout_side". Although it's documented as a percentage, it's clear from the code that it should be a decimal from 0.0 - 1.0. With the...

wjcarpenter

Support for IKEA SKÅDIS pegboard

5

https://www.ikea.com/us/en/p/skadis-pegboard-white-10321618/

MGX3D

Support for European pegboard

2

30mm spacing, 8mm round holes 15mm spacing, 4mm round holes 38mm spacing, 9mm square holes (Finland)

MGX3D

Thingiverse request - support for Triton LocBoard: http://www.tritonproducts.com/mobile-tool-carts/locboard/

MGX3D

Metric system: 3mm Thick, 4mm Hole Size, 25mm Hole Spacing. https://en.wikipedia.org/wiki/Perforated_hardboard

MGX3D

https://www.grainger.com/product/GRAINGER-APPROVED-42-1-2-x-24-Steel-Pegboard-6YB79 1 1/2" spacing, 3/8" square holes

MGX3D

First layer incomplete when printing upside down

1

when slicing upside down (with the tops of the hooks facing down) it appears that some of the model is not flush with the build plate. I have noticed when...

jeffminton