LordsWars
LordsWars
Hello, I have a question about the pins in the datasheet on the board there are BUSY and INT signals, and there are no connection of these pins from the...
  Well, with grief, I started the board. I checked everything works, it remains only to start the USB - FLASH CARD, this function is not implemented at all...
Hello, the original version is no longer there, because I tried to integrate work with a USB flash drive into the system and, as a result, abandoned this business ......
Hello, everything is correct, I use an external STM32 ST-LINK Utility bootloader, it needs a * .BIN file, which in your case means the firmware.bin file after compilation. I did...
[ROBIN2.zip](https://github.com/makerbase-mks/MKS-Robin/files/6033843/ROBIN2.zip) here is the BIN file that is now uploaded on my controller, it is possible to work as a 3D printer or as a milling cutter - the laser...
The whole point is who is flashing the MK, if you use the firmware via an SD card, you need to recode with shifts, and when flashing through ST-LINK 2.0,...
after compiling the program, I close the visual studio, run the program from the ST-LINK 2.0 programmer, then load the * .bin into the program and program the MC through...
[email protected] the main language of RU and EN only with a translator :) purely technical, visually understandable but not colloquial :) but about returning to the factory version, if there...
время ожидание ответа в оллама окне от момента вопроса до момента ответа доходит до 10 мин и ответ выводится до 10 минут чуть ли не по буквам :( ноутбук i3...
There is an example of work in Keil uVision5 with 2 screens via SPI bus and via 8080 + FMSC protocol on the STM32F407ZET platform https://stm32-base.org/boards/STM32F407ZGT6-STM32F4XX Moreover, SPI is software-based,...