sx1302_hal
sx1302_hal copied to clipboard
Lora-net
SX1302/SX1303 Hardware Abstraction Layer and Tools (packet forwarder...)
Hi, I am a newbie in LoRaWan and I have a project that requires the sensor data to pass through one SX1320 to another LoraWan Gateway. Can I modify the...
Hi, I have some questions regarding to Semtech SX1302CSSXXXGW1. I couldn't find any proper palce to ask my questions, sorry for inconviences. In the schematics, there are some pins to...
Dear support team, To get CE certification, We need to test module LORA EU868 again. However, we're troubled with generating TX signal with -6dBm I had run command: sudo ./test_loragw_hal_tx...
I am using Semtech LoRa® Corecell reference design V1.0 (which has SX1302 and SX1250) and testing Receive and Transmit examples. While receiving packets, packet information are printed on console which...
Hi All, I am using the SX1302 module over spi and the Two SX1272 is Node, I am sending from Two Nodes Uplink every 5sec once for checking the Packet...
I'm the electrical engineer on a project. As part of EMC testing, we found that for the first time after our system boots up, when I use test_loragw_hal_tx to transmit,...
add chip model ID output to enable easier determination between sx1302 and sx1303
Hello I just compared the CN490 and CN490 USB configuration as shown below, and there is large differences at the radio configuration level. Why ?  Thanks, Joel PS :...
Hello, I would like to reopen an issue that was previously discussed at https://github.com/Lora-net/sx1302_hal/issues/28. The issue deals with the mandatory temperature sensor required to make the RSSI compensation. All SX1302...