LoloMake60

USART 3 on MKS MONSTER 8 V2

11

Hi, I would like to have confirmation on the rt and tx usart3 pins. RX = PD8 and TX = PD9.  Thank you for your confirmation.

File step for Monster 8 v2?

2

Hi, Can you publish the file step for monster 8 v2? For 3D integration. Thank you.

Configuration for use MKS H43 on board Monster 8 V2

3

Hi, I would like to connect my MKS H43 screen to the monster 8 V2. What is the configuration to use USART1? For Marlin firmware. Thank you

Hi, I would like to connect my MKS H43 screen to the monster 8 V2. What is the configuration to use USART1?  For Marlin firmware.

Hello, Pin update to support board MKS robin nano V3.1 with original Ender3 v2 Display. But you have still to rewire display cable. Edit `pins_MKS_ROBIN_NANO_V3_common.h` and add: ```c #if EITHER(HAS_DWIN_E3V2,...

Is it possible to increase the number of extruders on MMU-DIP?

1

Hi, I wanted to know if it was possible to increase the number of extruders to 10? This should be possible by modifying the code and the led codes. Thanks.