LeighAS

 doing some investigating in home assistant in the mqtt configure page I have found that when i listen for the 2nd inverter's power value it returns the 1st inverters...

 I had a look again at why home assistant wasn't seeing the mqtt messages from both inverters from the eversol monitor pi. Today I've mentally moved the problem along...

 finally fixed it. basically its seems its a problem of scope. my $mqtt_serial = $inverters{$inverter}{'serial'}; is being declared and set outside of the sub ha_disc_config() which when I look...

sent PR. sorry it took me a while.

I may have to try this, i have failed a few times trying with usbasp devices EDIT my new usbasp device arrived. same problem as before observed. tried -F upload...

Yes its the older one about 2 years ago the v4.21 and usbasp programmer through the 6 pins on the slave. Havent tried a tinyisp flasher like adam welch yet...

Here are 3 that i havent soldered the header to flash then yet 

just found a work around for now to my energy dash board issue with the mqtt from the eversolar monitor not being formatted exactly as home assistant expects.  the...

More peeps on the hardware can be no bad thing. Thanks Greg.

I have now set the time and date. It was 8 hours ahead which would tally with when the sundown was happening too. Will keep using the template but hopefully...