SmartRC-CC1101-Driver-Lib
SmartRC-CC1101-Driver-Lib copied to clipboard
LSatan
Use of the i2c on wemos d1 mini
Hi there
I'm struggling to find a solution for my question perhaps you could help me... 😅 The gdo0 and 2 pins are connected to the i2c pin on the wemos I wold like to connect a oled display to display info How could I connect this 2 pins and configure them to be able to use the i2c?. Thanks for your help
hi, you still have D0, D3 and D4 to choose from for the gdo pins. change the pins in the sketch and try whether sending and receiving still works. Regards
Thanks @LSatan I've tried but impossible to program the wemos module Does any other configuration of the pin have to be done or only the d pin on the cc1101 library? Tha KS
OK This is the program I use or trying 😅 https://github.com/supermomo31/Somfy_MQTT But can't find where to change only in your library
You do not understand. it is changed in the skitze. not in my lib. in this case the pin is changed in somfy_remote.cpp.
regards
yes exactelly what i've done to have the DO and D3 to be used
but then the module have no output on the serial monitor like it hangs .
if i remove one of the GDO pins then it works normally that's why my question:
right i chaznge it to D4 meaning 2 and D0 16
perhaps do iu do something wrong on the pining numer?
ok i think it can only send. I will later make a few corrections to the somfy_remote.cpp. then gdo0 on D4. you won't need gdo2.
I wonder a little. gdo2 can actually only receive and not send. at least in ask mode. gdo0 can do both.
Do you think that better is to use a esp32 module in place of the wemos d1 mini?
So this mean that gdo0 have to used? Or not possible at all?
True we use gdo0.
Do you think that better is to use a esp32 module in place of the wemos d1 mini?
Esp32 is better. Now we check wemos d1 At First
Do you think that better is to use a esp32 module in place of the wemos d1 mini?
OK boss 👌😅
ok, check the somfy_mqtt.zip. Set the TxPin in the somfy_mqtt.ino after all the includes. give me a feedback on whether it works. Somfy_MQTT.zip
@LSatan thanks a lot.. That will cost me a beer 😉 I wil' try this tommorow morning and be back to you. By the way seems that even with the standard config when you remove the gdo2 wire seems working in TX only but not sure that the right way.
