zigbee2mqtt Received undefined command from '0'

Received undefined command from '0'

Open E99yBend opened this issue 9 months ago • 1 comments

What happened?

When setting MQTT into pairing mode I get the following message: "Received undefined command from '0'" I have added lots of devices without a problem but with this error it does not do any interviews with new devices.

What did you expect to happen?

I expected pairing mode to become active

How to reproduce it (minimal and precise)

Put MQTT in pairing mode. I get the message every time i do that

Zigbee2MQTT version

1.37.0

Adapter firmware version

6.10.3.0 build 297

Adapter

Sonoff zigbee 3.0

Setup

HA on PI running from SSD

Debug log

No response

May 06 '24 10:05 E99yBend

I am also getting this exact same error, although for me, it happens whether I am in pairing mode or not. When I click Disable join, or Permit Join, I immediately get the error. While updating Ikea firmware last night, I received the error every 3 minutes and 20 seconds in the logs. This morning, the error continues to be logged. It seems connected to the Ikea firmware updates that have showed up. So far, I have only been successful in updating 1 device out of 6 (3 Rodret, 2 Styrbar, 1 motion detector).