kicad-templates icon indicating copy to clipboard operation
kicad-templates copied to clipboard

Published 20 hours ago • verified publisher icon KiCad

Correction Power name on 40pin connector

Open Mimosa-oceanis opened this issue 4 years ago • 5 comments

The power name on the 40pin connector were wrong. Now it's corrected.

Mimosa-oceanis avatar Jun 27 '20 17:06 Mimosa-oceanis

CLA assistant check
All committers have signed the CLA.

CLAassistant avatar Jun 27 '20 17:06 CLAassistant

@Mimosa-oceanis Hi, thank you very much for your contribution, but I just reviewed it and to me it does not look like the original template is wrong. There are two nets, the one from the hat connector and the nets on the other side of the hat protection and selection jumpers.

Please describe in more detail what you think is wrong any why.

nickoe avatar Jun 28 '20 13:06 nickoe

Hi @nickoe I thought the same as you until I start routing the board. On the PCB the connection is wrong. If you check the 40 pins power 5v-hat doesn’t connect to the 5V on top layer. And it was simpler to just change the name in the schematic. And other point that way it also reduce the confusion because the way it was before was a bit confusing.

Hope I was clear.

Best regards

Mimosa-oceanis avatar Jun 28 '20 15:06 Mimosa-oceanis

So no push to master ?

Mimosa-oceanis avatar Aug 11 '20 15:08 Mimosa-oceanis

@Mimosa-oceanis Maybe you can share some images to clarity this?

evanshultz avatar Aug 12 '20 13:08 evanshultz