6EDL04N02PRXUMA1

[SchrodingersGat]

Adds symbol for the 6EDL04N02PRXUMA1 gate driver:

Three-phase half-bridge gate driver

Link

Datasheet

[cpresser]

Hi,

do you have a screenshot of the symbol wired up with transistors for the 3 half bridges? My feeling is that this symbol would be nicer if it would have 4 units. 3x half-bridge, 1x control+power. What do you think?

[SchrodingersGat]

The design of this symbol was based on the existing triple gate drivers in the library (see #2551)

I personally prefer it this style, rather than split, but library consistency would take preference I imagine

[cpresser]

The design of this symbol was based on the existing triple gate drivers in the library (see #2551)

I personally prefer it this style, rather than split, but library consistency would take preference I imagine

That is a good point. Lets leave it like it is. I will do a full review soon.

[cpresser]

• [x] Footprint and Filter are good
• [x] Pin names and numbers (funny side-node, the datasheet does not have pin17 as NC in the pin-table) check out.
• [ ] I am not sure about the pin-types for VB1 and VS1. The datasheet says 'power'. However 'passive' also matches FAN7888.
• [ ] Partname. The XUMA1suffix should be dropped as it is non functional: https://forum.digikey.com/t/infineon-opn-suffixes-example-ntma1/161
• [ ] Description and keywords: The current does not match what I could find in the datasheet: the typical output current can be given with 165 mA for pull-up and 375 mA for pull down.

[myfreescalewebpage]

@SchrodingersGat ping, are you still alive on this subject ?

[myfreescalewebpage]

Non news of original author, indicate this is Abandoned