Jan Post

Adding it makes sense if there is a V1.1 out but it differs from V1.0 and V2.0 (in my opinion)

Technically it is possible to measure the temperature of the heating coil itself by measuring the resistance and comparing it so the resistance of the coil at room temperature (...

> Can you fix this up @KarateBrot ? Will do 👍

I mean I will look at the requested changes and the problem with LPUART

FYI: [**My last push**](https://github.com/betaflight/betaflight/compare/2bcb9a210f65f74bb579b41940ce65a6f35e8c0b..cffa1845686647a20d361cb2d263ec942527b511) was necessary because I noticed that the LPFs for the motor RPM data don't get initialized **on the next power cycle in case you leave bidir...

Sorry to yet again invalidate your reviews... [**This last push**](https://github.com/betaflight/betaflight/compare/cffa1845686647a20d361cb2d263ec942527b511..96a0e6098c18c61838f19b28cd659d7e4128d849) aims towards avoiding possible future bugs and "tripping hazards", in case the `biquadFilter_t` struct changes at any point in the...

@ledvinap This PR is just a hack for finding better ICM42688 AAF settings. @ctzsnooze the UI filter is not that interesting for us. We normally use BF filters instead but...

This debug mode is probably the most widely used **by far** of all the debug modes. For backwards compatibility it's very important that we do not remove debug mode `GYRO_SCALED`....

Try 4.3.2 or 4.4.0

Agreed. Let's give it some attention right after the release of BF 4.5. But looks good to go to me.