K7MDL

Bug is in the 48KHz audio code. If you skip the audio changes and just run at 44.1K default, AND set the FFT sample rate at 44.100KHz in the .ino,...

They are in a bag in the junk pile. 2or 3 I think left. I have all the good ones I need. I think you are suggesting you have extra...

I observed this also in the DL1YCF fork I am using (with the latest updates applied). In CW modes it does not happen for me. I am on a HL2....

Investigating this more, debounce is used in gpio.c. the var settle_time is set to 50ms. I found making this value larger, say 150ms, I got more consistent behavior, and it...

I believe I solved the problem. The (regular) switches record millis into a switch.debounce value for each switch. The encoder switches have the same structure for switch state but the...

The solution has been working well for normal switches that you release for action. For gpio PTT (only) where you need action and debounce on both edges, level sensing polling...

I have now implemented MIDI keyer config via the CW menu and will have the Teensy MIDI keyer handle PTT (with debounce) and CW. Also takes care of lack of...

Have PTT from a gpio pin now working. I am using pin 12 on my controller1 version since I have a GPS on the serial port pins 14 and 15....

Things have progress on this topic. I have found that without external hardware debounce that settle time of 0ms works best for me. The i2c switches do not seem to...

It does seem that turning off local audio helps reduce sequence errors but they can be induced through several other means. Listen to a busy 40M band vs a quiet...