Marlin

Marlin copied to clipboard

Screen firmware not flashing

16

I've followed all instructions on the Readme and the screen doesn't even pretend to flash. I've tried all three files. It just boots up normally with the stock firmware. This...

AJinabadMood

### Description When booting Ender 3, screen holds on backlit but black. The only way to finish the boot is for filament to be loaded in the runnout sensor. E3V2-BLTouch-3x3-HS-v4.2.2-v2.0.1.bin...

oliveman521

### Description When the print time counter reaches 100 hours, the counter returns to zero ### Steps to Reproduce 1. [First Step] 2. [Second Step] 3. [and so on...] **Expected...

noamix

Hello, yesterday I have changed to the Alex-Marlin firmware. Now I have unfortunately the following problem, whenever I want to level the bed on my Voxelab Aquila X2 N32, I...

sT4sHi

HOMING FAIL. Z AXIS NOT TRAVELING. I have installed the E3V2-BLTouch-3x3-v4.2.2-v2.0.1.bin. I have also tried the 5x5 probe area as a shot in the dark. The issue I am having is when running the mesh or homing I do not get Z travel. X and Y perform fine while homing but I then receive a Printer Kill Reason of "Homing Failed, Restart Required". I have tried to manually step the Z with not response. It appears my z is no longer reading. Has anyone ran into this issue and have a solution?

3

### Description ### Steps to Reproduce 1. [First Step] 2. [Second Step] 3. [and so on...] **Expected behavior:** [What you expect to happen] **Actual behavior:** [What actually happens] #### Additional...

BGood320

Ender 3 v2

3

Hello to all. I have updated my printer to Jyers and now when i use bed leveling it crash to the frame.. like is on the video.. and that happend...

maticekkkk

E3v2 Sprite pro 300'??

1

I have an Ender 3v2 I recently installed a sprite pro on but I can't get it to run hotter than 260. I would like to use the full 300...

CHARGERFORCE

Firmware files not Mac compatible...

1

I have a Mac computer. I'm trying to install new firmware on my Ender 3, and I can't even open the file to put it on my MicroSD card because...

b0gGoblin

v2.0.1 - Major Fixes

1

Your firmware is for the Ender 3 V2, does it also work with the normal Ender 3? Greetings Chris

KochChr86

Only a suggestion, but rather than wasting screen space on x/y positioning etc, could we have layer height and percentage of that layer? It would be useful in filament changes.

beachcomberbob