GoB
GoB copied to clipboard
JoseConseco
menu bar bugged on 4k monitor
So, I just recently updated after a while, when I did I noticed the buttons slid all the way over to right side. after remove and reinstall the buttons appear at the end of the tab section, then immediately slide over (like continuously which causes a drop down effect I think? Anyhow, the bug I am getting is super trivial and mega annoying. When I have GoB enabled, whenever I use any overhead menu bar buttons a I get a strip afterwards that covers them. Only happens on the 4k Samsung. works fine on 1080. If I disable GoB I don't have the issue. I also notice that the entire menu/tabs bar size is jittery when I mouseover when GoB is on and passover anything.
thanks for the report, i encountered this a couple times and was not able to reproduce. I will give it another go
i have not been able to reproduce thsi so far, what blender version are you running? and do you have that 4k screen by any chance on a laptop or a setup with 2 different screen sizes?
3.2.1. And I do have 2 different screen sizes. A 4K and a 1080. It doesn’t happen on the 1080 at all. Also different refresh rates. 144 1080 and 60 on the 4K
On Sat, Jul 16, 2022 at 11:43 Daniel G @.***> wrote:
i have not been able to reproduce thsi so far, what blender version are you running? and do you have that 4k screen by any chance on a laptop or a setup with 2 different screen sizes?
— Reply to this email directly, view it on GitHub https://github.com/JoseConseco/GoB/issues/344#issuecomment-1186134250, or unsubscribe https://github.com/notifications/unsubscribe-auth/AMLHL5JTNOFKYTX3JXWVDFTVUJ75BANCNFSM53P2S7PA . You are receiving this because you authored the thread.Message ID: @.***>