Jonseed

  For example, you can see here that I lasso'd the cat's face to turn it into a lion, and I get hard edges at...

Increasing the mask expansion would just make the hard edge worse. This is what the mask looks like after increasing expansion to 30. 

It seems the plugin is placing a rectangular bounding box directly around the original lasso area, without regard for the mask blur or mask expansion values. So if you add...

@AbdullahAlfaraj The lasso offset in 1.3.3 seems to have fixed this. Thank you! But now the mask blur doesn't seem to work, or only works about half the time. I...

In Auto1111, with the inpaint area set to "only masked," the resolution of the inpainting generation is whatever is set as width and height, resizing the masked area to that...

I see the same issue, although it only shows when the face detection is set to YuNet. If I set it to mediapipe, then that error goes away.

Thanks for the comments about switching to mediapipe. That does seem to make it work again. Really wish this extension was still maintained, as it works quite differently than adetailer...

@kex0 adetailer and reactor don't work on an entire folder of images, from what I can tell. Or maybe I'm just not using it right? Ah, gotcha. I don't actually...

@kex0 I'll see if I can use adetailer in img2img "batch" mode...

@kex0 I think I finally got adetailer to work like batch-face-swap in Auto's "batch" mode. You have to set it to regular img2img "batch" mode, which is in the img2img...