JochenSchmidt

Does MQTT still run over Wifi to IOBroker or something? Which Cerbo and Multiplus firmware is on it? What is set in the Cerbo, which voltage sensor is used? Have...

@Linusten Ok, then the cause of the alarm comes from the VE.Bus system (MP). One of the MPs thinks the Voltage is gone for a moment. I've had this before...

@Linusten Please have a look at Issue #225 I made some tests - after switching WLAN off nothing were bad. After WLAN switching on, the system switches completly off and...

@chapulino What happens if you turn off the WiFi and turn it back on again after a few minutes? Is it reconnecting?

@chapulino You wrote: This does not influence its operation since it is communicated by Modbus with a CERBO, but the controller stops sending monitoring data via MQTT Is that right...

> There is a Modbus cable communication with the Victron system. Sorry chapulino, I don´t understand that..... you mean that you have a modbus cable connection from diyBMS to Victron...

Before 9 days I installed a tiny old Eee PC with PuTTy logging the ESP32 USB stream. But since then there hasn't been another internal error in the diyBMS. I'll...

@Linusten > Got this "Internal error alarm: Alarm" also a few times, dont really know what is causing the issue.... Did you also have a shutdown from the Multiplus /...

@Linusten Do you have the possibility to log the ESP32 via USB with PuTTy?