Jiao Xianjun

"clock drift is too small to adjust" To my understanding, the clock drift is expected to be small, right? So this "good thing" will cause problem?

it might due to some issue we are working on. 2.4GHz is quite busy, and some times the receiver even is busy with "fake" signal (bad fcs). in this case,...

Tow SDRs (one client, one AP) can work in 2.4GHz and communicate with each other without issue.

we are preparing new releases for this.

Could you try the new release?

Please follow this https://github.com/open-sdr/openwifi/blob/master/doc/app_notes/frequent_trick.md#receiver-sensitivity-control to make your receiver less sensitive. For instance, set the threshold to 70 or 60. Share me the dmesg output when you have set drv_rx 7...

Those fffffff should be beacon? Can you set that AP in 20MHz mode (a or n) and make sure disable 11b? what about “iwlist sdr0 scan”

I just did 7035 test: ``` ./wgd.sh ifconfig sdr0 up ./monitor_ch.sh sdr0 6 tcpdump -i sdr0 ``` I can see lots of beacon.

Did you figure out the reason?

Great news! Here are some replies/comments: openwifi: device tree modified, ad9361 part same as antsdr except 2rx-2tx is disabled -- if this is enabled, RX/TX tuning will fail on high...