JasonY00

Please close the issue if resolved. thanks Jason

I can’t say that I pursued the child bridge concept too much. It didn’t seem to work. My solution was to just run up another instance of Homebridge and split...

I think if you don't need to do it, then don't complicate things. It's not always worth doing something just because you can. You can have all of your other...

I just wanted to say that due to necessity and simplification with the EOL of the homebridge-gsh (google voice control plugin) on 1st December 2024, I have managed to get...

Ok. I think it looks ok. I have tested it on a pi running homebridge and a pi running Home Assistant with homebridge run up on the same pi as...

Hi Glenn, Homekit doesn't support Current Measurement, however, if you set your current measurement device up as temperature sensors in Homebridge, they will display just fine. I use this for...

Hi Glenn, As far as support goes…there is none except for the goodwill of the development community. Pretty much everyone useful and interested in C-bus/homekit is here and in the...

Hi Glenn, I am back from travelling and had time to mock up a single current sensor from the three phases. I have used Node Red to input three phases...

Hi Glenn, can you close this issue if you think it’s resolved? cheers Jason

Hi Glenn, Putting the three phases on one channel of the current measurement unit won’t work. The three power phases supplied to you are voltage sine waves that are 120...